clri(ADM)
clri --
clear inode
Syntax
/etc/clri filesystem i-number ...
Description
clri writes zeros on the 64 bytes occupied by the inode
numbered i-number. filesystem must be a special
filename referring to a device containing a filesystem. After clri
is executed, any blocks in the affected file will show up as ``missing''
if the filesystem is checked with
fsck(ADM).
Use clri only in emergencies and exercise extreme care.
Read and write permission is required on the specified filesystem
device. The inode becomes allocatable.
The primary purpose of this command is to remove a file which,
for some reason, does not appear in a directory.
If you use clri to destroy an inode which does appear in a directory,
track down the entry and remove it. Otherwise, when the inode is reallocated
to some new file, the old entry will still point to this file.
At that point, removing the old entry will destroy the new file.
The new entry will again point to an unallocated inode,
so the whole cycle is likely to be repeated.
Limitations
If the file is open, clri is likely to be ineffective.
This utility does not work on dosfs filesystems.
See also
fsck(ADM),
ncheck(ADM)
Standards conformance
clri is conformant with
AT&T SVID Issue 2.
© 2005 The SCO Group, Inc. All rights reserved.
SCO OpenServer Release 6.0.0 -- 03 June 2005