NAME

bio — Block IO ioctl tunnel pseudo-device

SYNOPSIS

pseudo-device bio

DESCRIPTION

The bio driver provides userland applications ioctl(2) access to devices otherwise not found as /dev nodes. The /dev/bio device node operates by delegating ioctl calls to a requested device driver. Only drivers which have registered with the bio device can be accessed via this interface.

The following device drivers register with bio for volume management:

arcmsr(4)

Areca Technology Corporation SATA RAID controller

cac(4)

Compaq RAID array controller

ciss(4)

Compaq Smart ARRAY 5/6 SAS/SATA/SCSI RAID controller

mfi(4)

LSI Logic & Dell MegaRAID SAS RAID controller

The following ioctl calls apply to the bio device:

BIOCLOCATE

Locate a named device and give back a cookie to the application for subsequent ioctl calls. The cookie is used to tunnel further ioctls to the right device.

BIOCINQ

Retrieve number of volumes and physical disks for a specific device.

BIOCDISK

Retrieve detailed information for the specified physical disk. Information returned can include status, size, channel, target, lun, vendor name, serial number, and processor device (ses).

BIOCDISK_NOVOL

Is just the same as BIOCDISK but doesn't require the disks to be in volume sets, so this applies to any physical disk connected to the controller.

Note: this ioctl might not be supported on all hardware.

BIOCVOL

Retrieve detailed information for the specified volume. Information returned can include status, size, RAID level, number of disks, device name association (sd?) and vendor name.

BIOCALARM

Control the alarm beeper on the device. Supported states are: disable alarm, enable alarm, silence alarm, status and test alarm.

Note: These options might not be supported on all hardware.

BIOCBLINK

Blink an LED of the specified physical disk. Supported blink states are: blink LED, unblink LED and blink alarm LED.

Note: This option is only supported if the disk is governed by ses(4) and the hardware supports hardware blinking.

BIOCSETSTATE

Alter the state of specified physical disk. Supported states are: create/remove hot-spare, create/remove pass through disk, start/stop consistency check in a volume, online disk and offline disk.

Note: These options might not be supported on all hardware.

BIOCVOLOPS

For operations in volume sets. It's able to create and remove a volume set in a supported RAID controller.

Note: this ioctl might not be supported on all hardware.

FILES

/dev/bio

ioctl tunnel device

SEE ALSO

ioctl(2), bioctl(8)

HISTORY

The bio driver first appeared in OpenBSD 3.2 and NetBSD 4.0.

AUTHORS

The bio driver was written by Niklas Hallqvist <niklas@openbsd.org>. The API was written by Marco Peereboom <marco@openbsd.org> and was extended even more for NetBSD by Juan Romero Pardines <xtraeme@netbsd.org>.