Examines i-nodes.
istat {FileName | i-nodeNumber Device}
The istat command displays the i-node information for a particular file. You can specify the file either by providing a file or directory name with the FileName parameter or by providing an i-node number with the i-nodeNumber parameter and a device name with the Device parameter. You can specify the Device parameter as either a device name or as a mounted file system name.
If you specify the FileName parameter, the istat command writes the following information about the file:
Note: The owner and group names for remote files are taken from the local /etc/passwd file.
If you specify the i-nodeNumber and Device parameters, the istat command also displays, in hexadecimal values, the block numbers recorded in the i-node.
Note: The Device parameter cannot refer to a remote device.
istat /usr/bin/ksh
This
command displays the i-node information for the /usr/bin/ksh file.
The information looks similar to the following: Inode 10360 on device 10/6 File
Protection: r-xr-xr-x
Owner: 2(bin) Group: 2(bin)
Link count: 2 Length 372298 bytes
Last updated: Wed May 13 14:08:13 1992
Last modified: Wed May 13 13:57:00 1992
Last accessed: Sun Jan 31 15:49:23 1993
istat 10360 /dev/hd2
This command
displays the information contained in the i-node identified by the
number 10360 on the /dev/hd2 device. In addition
to the information shown in Example 1, this displays: Block pointers (hexadecimal):
2a9a 2a9b 2a9c 2a9d 2a9e 2a9f 2aa0 2aa1
These
numbers are addresses of the disk blocks that make up the /usr/bin/ksh file.Item | Description |
---|---|
/usr/bin/istat | Contains the istat command. |