adss(7)

adss -- Adaptec AIC-6x60 family SCSI host adapter subsystem

Description

The Adaptec AIC-6x60 family host adapter driver provides a Storage Device Interface (SDI)-compliant interface to any Adaptec Host Adapters based on the Adaptec AIC-6x60 family of SCSI controller chips. These devices include AHA-1505, AHA-1510, AHA-1510A, AHA-1520/1522, and AHA-1720A/1722A as well as any motherboard implementations using the AIC-6260 or the AIC-6360 SCSI chips.

The Adaptec AIC-6x60 family host adapter driver enables SDI-compliant target drivers (such as sd01 and st01) to communicate on the SCSI bus with target controllers and logical units. This allows normal access to mass-storage devices using standard system interfaces and filesystems.

It is also possible for an application to access the SCSI bus subsystem directly by using the pass-through interface. See pt_open(3X).

NOTE: Adaptec SCSI controllers cannot be used reliably with Emulex SCSI/ESDI bridge controllers (also known as AT&T DCM/4E). This is due to hardware-induced timing differences between these bridge controllers and any SCSI controllers other than the one that they were designed to be used with. It is not possible to provide a software solution to this problem.

Exercise extreme caution when using the pass-through interface. It is possible to interfere with normal system I/O and cause hangs if pass-through is used to an active device. Pass-through should only be used to a device that is otherwise quiescent.

Files

/usr/include/sys/adss.h
/usr/include/sys/scsi.h
/usr/include/sys/sdi.h
/usr/include/sys/sdi_edt.h
/usr/include/sys/sdi_comm.h
/etc/conf/pack.d/adss/space.c

References

adsa(7), adsc(7), adse(7), dpt(7), ioctl(2), mcis(7), sc01(7), sd01(7), sdi(7), st01(7), sw01(7), wd7000(7)