t_error(3xti)

t_error -- write an error message

Synopsis

cc [options] file -lnsl

#include <xti.h>

int t_error(char *errmsg);

Description

This function is a TLI/XTI local management routine used to generate a message under error conditions. t_error writes a message on the standard error file describing the last error encountered during a call to a TLI/XTI function.

The argument string errmsg is user supplied and may be set to give context to the error. The message returned by t_error prints in the following format: the user-supplied error message followed by a colon and the standard transport function error message for the current value contained in t_errno.

Parameters

errmsg: a user-supplied error message that gives context to the error.
t_errno: index to a user-specified message array.
t_errlist: points to the array of user-supplied message strings.
t_nerr: maximum number of messages in the user-specified message array.

State transitions

t_error may be issued from any valid state except T_UNINIT and has no effect on the entry state at exit.

Files

/usr/lib/libxti.so: X/Open^® Transport Interface Library (shared object)
/usr/lib/libnsl.so: Network Services Library (shared object)
/usr/lib/locale/locale/LC_MESSAGES/uxnsl

Usage

On return, t_errno is set only when an error occurs and is not cleared on subsequent successful calls.

If the returned value of t_errno has been set to TSYSERR, t_error will also print the standard error message for the current value contained in errno (see intro(2)).

Return values

Upon completion, a value of 0 is returned. No errors are defined.

References

intro(2), t_strerror(3xti)

Examples

Following a t_connect function call, which might fail on a transport endpoint fd2 because a bad address was detected, a call to t_error might be issued to check for a possible failure:

   t_error("t_connect failed on fd2");

If the t_connect fails, t_errno is set to the appropriate value, and the diagnostic message would print as:

   t_connect failed on fd2: Incorrect transport address format

where t_connect failed on fd2 tells the user which function failed on which transport endpoint, and Incorrect transport address format identifies the specific error that occurred.