tftp(1tcp)


tftp -- trivial file transfer program

Synopsis

tftp [host [port]]

Description

The tftp command is the user interface to the Internet TFTP (Trivial File Transfer Protocol), which allows users to transfer files to and from a remote machine.

Usage

The remote host, and optionally the port, may be specified on the command line, in which case tftp uses host as the default host for future transfer (see the connect command below).

host may be a resolvable domain name, an IPv4 address, or an IPv6 address. port must be specified as an integer.

Commands

Once tftp is running, it issues the prompt tftp> and recognizes the following commands:

connect host [port]
Set the host (and optionally port) for transfers. The TFTP protocol, unlike the FTP protocol, does not maintain connections between transfers; thus, the connect command does not actually create a connection, but merely remembers what host is to be used for transfers. You do not have to use the connect command; the remote host can be specified as part of the get or put commands.

mode transfer-mode
Set the mode for transfers; transfer-mode may be one of ascii or binary. The default is ascii.

put filename

put localfile remotefile

put filename1 filename2 . . . filenameN remote-directory
Transfer a file, or a set of files, to the specified remote file or directory. The destination can be in one of two forms: a filename on the remote host if the host has already been specified, or a string of the form

host:filename

to specify both a host and filename at the same time. If the latter form is used, the specified host becomes the default for future transfers. If the remote-directory form is used, the remote host is assumed to be running the UNIX system.


get filename

get remotename localname

get filename1 filename2 filename3 . . . filenameN
Get a file or set of files (three or more) from the specified remote sources. source can be in one of two forms: a filename on the remote host if the host has already been specified, or a string of the form

host:filename

to specify both a host and filename at the same time. If the latter form is used, the last host specified becomes the default for future transfers.


quit
Exit tftp. An EOF also exits.

verbose
Toggle verbose mode.

trace
Toggle packet tracing.

status
Show current status.

rexmt retransmission-timeout
Set the per-packet retransmission timeout, in seconds.

timeout total-transmission-timeout
Set the total transmission timeout, in seconds.

ascii
Shorthand for mode ascii.

binary
Shorthand for mode binary.

? [command-name . . . ]
Print help information.

Warnings

Because there is no user-login or validation within the TFTP protocol, many remote sites restrict file access in various ways. Approved methods for file access are specific to each site, and therefore cannot be documented here.

When using the get command to transfer multiple files from a remote host, three or more files must be specified. The command returns an error message if only two files are specified.

References

tftpd(1Mtcp)
© 2004 The SCO Group, Inc. All rights reserved.
UnixWare 7 Release 7.1.4 - 25 April 2004