cmdtrace(1tcl)


cmdtrace -- print trace statement for executing commands

Synopsis

cmdtrace level | on [noeval] [notruncate] [procs] [fileid] | off | depth

Description

Prints a trace statement for all commands executed at depth of level or below (1 is the top level). If on is specified, all commands at any level are traced.

The most common use of this command is to enable tracing to a file during the development. If a failure occurs, a trace is then available when needed. Command tracing will slow down the execution of code, so it should be removed when code is debugged. The following command will enable tracing to a file for the remainder of the program:

   cmdtrace on [open cmd.log w]

Options


noeval
Causes arguments to be printed unevaluated. If noeval is specified, the arguments are printed before evaluation. Otherwise, they are printed afterwards.

If the command line is longer than 60 characters, it is truncated to 60 and a ``...'' is postpended to indicate that there was more output than was displayed. If an evaluated argument contains a space, the entire argument is enclosed within braces ({}) to allow the reader to visually separate the arguments from each other.


notruncate
Disables the truncation of commands and evaluated arguments.

procs
Enables the tracing of procedure calls only. Commands that are not procedure calls (that is, calls to commands that are written in C, C++ or some object-compatible language) are not traced if the procs option is specified. This option is particularly useful for greatly reducing the output of cmdtrace while debugging.

fileid
This is a file id as returned by the open command. If specified, then the trace output will be written to the file rather than stdout. A stdio buffer flush is done after every line is written so that the trace may be monitored externally or provide useful information for debugging problems that cause core dumps.

off
Turns off all tracing.

depth
Returns the current maximum trace level, or zero if trace is disabled.

25 April 2004
© 2004 The SCO Group, Inc. All rights reserved.
UnixWare 7 Release 7.1.4 - 25 April 2004