Register as a power-managed device driver
#include <sys/io-char.h>
int iochar_regdrv_power(TTYDEV *dev,
TTYINITPOWER *init,
unsigned flags);
- dev
- A pointer to the structure that represents the specific device that data has been received on.
- init
- A pointer to the structure that represents the power-managed device registration info.
- flags
- Common power-management flags. One of:
- PWR_INIT_DRVREG — register as a power-managed device.
- PWR_INIT_DRVPSTORE — driver wants its own persistent storage object .
- PWR_INIT_DRVSAVE — driver wants to store data for HWVOL or NORAM
- PWR_INIT_DRVOVERRIDE — driver will assume all setpower functionality.
- PWR_INIT_DRVNOFLOWCTL — driver should delay
before powering down for flow control.
- PWR_INIT_NOPMM —indicates that there is no power manager running on initializing.
- PWR_WAITING_DRAIN — a power change is waiting for device to drain.
- PWR_FLOW_PAGED — device is HW or SW paged due to power.
- PWR_EVENT_DEVCTL — check devctl blocking queue.
- PWR_EVENT_DEVWAKEUP — device wants to wake up
due to an external event such as a device wakeup event (this is NOT a CPU wakeup) .
- PM_MODE_HW_NONE — power mode does not support any hardware access .
- PM_MODE_HW_TX — power mode allows transmit.
- PM_MODE_HW_RX — power mode allows receive.
- PM_MODE_HW_CTRL — power mode allows control over RTS/DTR lines.
- PM_MODE_HW_REGREAD — power mode allows registers to be read .
- PM_MODE_HW_REGWRITE — power mode allows registers to be written.
- PM_MODE_HW_ALL — power mode allows full device access .
- PM_MODE_HW_RXTX — power mode allows transmit and receive.
- PM_MODE_HW_REG — power mode allows registers to be read and written.
- PM_MODE_HW_DRAIN — power mode allows registers to be read and be transmitted.
- PM_MODE_HW_OFF —OFF modes should not allow any HW access.
- PM_MODE_HW_ACTIVE — ACTIVE modes should allow full HW access.
This function registers with io-char as a power-managed driver.
If you're writing a power-managed device driver, call iochar_regdrv_power()
before calling ttc(TTC_INIT_POWER, ...).
- 0
- Success.
- -1
- An error occurred.
QNX Neutrino
Safety: | |
Cancellation point |
No |
Interrupt handler |
No |
Signal handler |
No |
Thread |
No |
TTYDEV,
ttc(),
tti(),
tto()