| UVM(9) | Kernel Developer's Manual | UVM(9) |
In addition to exporting these services, UVM has two kernel-level processes: pagedaemon and swapper. The pagedaemon process sleeps until physical memory becomes scarce. When that happens, pagedaemon is awoken. It scans physical memory, paging out and freeing memory that has not been recently used. The swapper process swaps in runnable processes that are currently swapped out, if there is room.
There are also several miscellaneous functions.
uvm_init() sets up the UVM system at system boot time, after the console has been setup. It initializes global state, the page, map, kernel virtual memory state, machine-dependent physical map, kernel memory allocator, pager and anonymous memory sub-systems, and then enables paging of kernel objects.
uvm_init_limits() initializes process limits for the named process. This is for use by the system startup for process zero, before any other processes are created.
uvm_setpagesize() initializes the uvmexp members pagesize (if not already done by machine-dependent code), pageshift and pagemask. It should be called by machine-dependent code early in the pmap_init() call (see pmap(9)).
uvm_swap_init() initializes the swap sub-system.
uvm_fault() is the main entry point for faults. It takes orig_map as the map the fault originated in, a vaddr offset into the map the fault occurred, and access_type describing the type of access requested. uvm_fault() returns a standard UVM return value.
uvm_io() performs the I/O described in uio on the memory described in map.
uvm_pagealloc() allocates a page of memory at virtual address off in either the object uobj or the anonymous memory anon, which must be locked by the caller. Only one of uobj and anon can be non NULL. Returns NULL when no page can be found. The flags can be any of
#define UVM_PGA_USERESERVE 0x0001 /* ok to use reserve pages */ #define UVM_PGA_ZERO 0x0002 /* returned page must be zero'd */
UVM_PGA_USERESERVE means to allocate a page even if that will result in the number of free pages being lower than uvmexp.reserve_pagedaemon (if the current thread is the pagedaemon) or uvmexp.reserve_kernel (if the current thread is not the pagedaemon). UVM_PGA_ZERO causes the returned page to be filled with zeroes, either by allocating it from a pool of pre-zeroed pages or by zeroing it in-line as necessary.
uvm_pagerealloc() reallocates page pg to a new object newobj, at a new offset newoff.
uvm_pagefree() frees the physical page pg. If the content of the page is known to be zero-filled, caller should set PG_ZERO in pg->flags so that the page allocator will use the page to serve future UVM_PGA_ZERO requests efficiently.
uvm_pglistalloc() allocates a list of pages for size size byte under various constraints. low and high describe the lowest and highest addresses acceptable for the list. If alignment is non-zero, it describes the required alignment of the list, in power-of-two notation. If boundary is non-zero, no segment of the list may cross this power-of-two boundary, relative to zero. nsegs is the maximum number of physically contiguous segments. If waitok is non-zero, the function may sleep until enough memory is available. (It also may give up in some situations, so a non-zero waitok does not imply that uvm_pglistalloc() cannot return an error.) The allocated memory is returned in the rlist list; the caller has to provide storage only, the list is initialized by uvm_pglistalloc().
uvm_pglistfree() frees the list of pages pointed to by list. If the content of the page is known to be zero-filled, caller should set PG_ZERO in pg->flags so that the page allocator will use the page to serve future UVM_PGA_ZERO requests efficiently.
uvm_page_physload() loads physical memory segments into VM space on the specified free_list. It must be called at system boot time to set up physical memory management pages. The arguments describe the start and end of the physical addresses of the segment, and the available start and end addresses of pages not already in use. If a system has memory banks of different speeds the slower memory should be given a higher free_list value.
uvm_pageout() is the main loop for the page daemon.
uvm_scheduler() is the process zero main loop, which is to be called after the system has finished starting other processes. It handles the swapping in of runnable, swapped out processes in priority order.
uvm_loan() loans pages in a map out to anons or to the kernel. map should be unlocked, start and len should be multiples of PAGE_SIZE. Argument flags should be one of
#define UVM_LOAN_TOANON 0x01 /* loan to anons */ #define UVM_LOAN_TOPAGE 0x02 /* loan to kernel */
v should be pointer to array of pointers to struct anon or struct vm_page, as appropriate. The caller has to allocate memory for the array and ensure it's big enough to hold len / PAGE_SIZE pointers. Returns 0 for success, or appropriate error number otherwise. Note that wired pages can't be loaned out and uvm_loan() will fail in that case.
uvm_unloan() kills loans on pages or anons. The v must point to the array of pointers initialized by previous call to uvm_loan(). npages should match number of pages allocated for loan, this also matches number of items in the array. Argument flags should be one of
#define UVM_LOAN_TOANON 0x01 /* loan to anons */ #define UVM_LOAN_TOPAGE 0x02 /* loan to kernel */
and should match what was used for previous call to uvm_loan().
The uao_create(), uao_detach(), and uao_reference() functions operate on anonymous memory objects, such as those used to support System V shared memory. uao_create() returns an object of size size with flags:
#define UAO_FLAG_KERNOBJ 0x1 /* create kernel object */ #define UAO_FLAG_KERNSWAP 0x2 /* enable kernel swap */
which can only be used once each at system boot time. uao_reference() creates an additional reference to the named anonymous memory object. uao_detach() removes a reference from the named anonymous memory object, destroying it if removing the last reference.
uvm_chgkprot() changes the protection of kernel memory from addr to addr + len to the value of rw. This is primarily useful for debuggers, for setting breakpoints. This function is only available with options KGDB.
uvm_kernacc() checks the access at address addr to addr + len for rw access in the kernel address space.
uvm_vslock() and uvm_vsunlock() control the wiring and unwiring of pages for process p from addr to addr + len. These functions are normally used to wire memory for I/O.
uvm_meter() calculates the load average.
uvm_proc_fork() forks a virtual address space for process' (old) p1 and (new) p2. If the shared argument is non zero, p1 shares its address space with p2, otherwise a new address space is created. This function currently has no return value, and thus cannot fail. In the future, this function will be changed to allow it to fail in low memory conditions.
uvm_grow() increases the stack segment of process p to include sp.
uvn_findpages() looks up or creates pages in uobj at offset offset, marks them busy and returns them in the pps array. Currently uobj must be a vnode object. The number of pages requested is pointed to by npagesp, and this value is updated with the actual number of pages returned. The flags can be
#define UFP_ALL 0x00 /* return all pages requested */ #define UFP_NOWAIT 0x01 /* don't sleep */ #define UFP_NOALLOC 0x02 /* don't allocate new pages */ #define UFP_NOCACHE 0x04 /* don't return pages which already exist */ #define UFP_NORDONLY 0x08 /* don't return PG_READONLY pages */
UFP_ALL is a pseudo-flag meaning all requested pages should be returned. UFP_NOWAIT means that we must not sleep. UFP_NOALLOC causes any pages which do not already exist to be skipped. UFP_NOCACHE causes any pages which do already exist to be skipped. UFP_NORDONLY causes any pages which are marked PG_READONLY to be skipped.
uvm_vnp_setsize() sets the size of vnode vp to newsize. Caller must hold a reference to the vnode. If the vnode shrinks, pages no longer used are discarded.
/* vm_page constants */
int pagesize; /* size of a page (PAGE_SIZE): must be power of 2 */
int pagemask; /* page mask */
int pageshift; /* page shift */
/* vm_page counters */
int npages; /* number of pages we manage */
int free; /* number of free pages */
int paging; /* number of pages in the process of being paged out */
int wired; /* number of wired pages */
int reserve_pagedaemon; /* number of pages reserved for pagedaemon */
int reserve_kernel; /* number of pages reserved for kernel */
/* pageout params */
int freemin; /* min number of free pages */
int freetarg; /* target number of free pages */
int inactarg; /* target number of inactive pages */
int wiredmax; /* max number of wired pages */
/* swap */
int nswapdev; /* number of configured swap devices in system */
int swpages; /* number of PAGE_SIZE'ed swap pages */
int swpginuse; /* number of swap pages in use */
int nswget; /* number of times fault calls uvm_swap_get() */
int nanon; /* number total of anon's in system */
int nfreeanon; /* number of free anon's */
/* stat counters */
int faults; /* page fault count */
int traps; /* trap count */
int intrs; /* interrupt count */
int swtch; /* context switch count */
int softs; /* software interrupt count */
int syscalls; /* system calls */
int pageins; /* pagein operation count */
/* pageouts are in pdpageouts below */
int pgswapin; /* pages swapped in */
int pgswapout; /* pages swapped out */
int forks; /* forks */
int forks_ppwait; /* forks where parent waits */
int forks_sharevm; /* forks where vmspace is shared */
/* fault subcounters */
int fltnoram; /* number of times fault was out of ram */
int fltnoanon; /* number of times fault was out of anons */
int fltpgwait; /* number of times fault had to wait on a page */
int fltpgrele; /* number of times fault found a released page */
int fltrelck; /* number of times fault relock called */
int fltrelckok; /* number of times fault relock is a success */
int fltanget; /* number of times fault gets anon page */
int fltanretry; /* number of times fault retrys an anon get */
int fltamcopy; /* number of times fault clears "needs copy" */
int fltnamap; /* number of times fault maps a neighbor anon page */
int fltnomap; /* number of times fault maps a neighbor obj page */
int fltlget; /* number of times fault does a locked pgo_get */
int fltget; /* number of times fault does an unlocked get */
int flt_anon; /* number of times fault anon (case 1a) */
int flt_acow; /* number of times fault anon cow (case 1b) */
int flt_obj; /* number of times fault is on object page (2a) */
int flt_prcopy; /* number of times fault promotes with copy (2b) */
int flt_przero; /* number of times fault promotes with zerofill (2b) */
/* daemon counters */
int pdwoke; /* number of times daemon woke up */
int pdrevs; /* number of times daemon rev'd clock hand */
int pdfreed; /* number of pages daemon freed since boot */
int pdscans; /* number of pages daemon scanned since boot */
int pdanscan; /* number of anonymous pages scanned by daemon */
int pdobscan; /* number of object pages scanned by daemon */
int pdreact; /* number of pages daemon reactivated since boot */
int pdbusy; /* number of times daemon found a busy page */
int pdpageouts; /* number of times daemon started a pageout */
int pdpending; /* number of times daemon got a pending pageout */
int pddeact; /* number of pages daemon deactivates */
All structure and types whose names begin with “vm_” will be renamed to “uvm_”.
Charles D. Cranor and Gurudatta M. Parulkar, The UVM Virtual Memory System, Proceedings of the USENIX Annual Technical Conference, USENIX Association, 117-130, June 6-11, 1999, http://www.usenix.org/event/usenix99/full_papers/cranor/cranor.pdf.
UVM appeared in NetBSD 1.4.
Matthew Green <mrg@eterna.com.au> wrote the swap-space management code and handled the logistical issues involved with merging UVM into the NetBSD source tree.
Chuck Silvers <chuq@chuq.com> implemented the aobj pager, thus allowing UVM to support System V shared memory and process swapping.
| June 1, 2011 | NetBSD 6.1 |