XGE(4) Kernel Interfaces Manual XGE(4)

NAME

xgeNeterion Xframe-I Ten Gigabit Ethernet driver

SYNOPSIS

xge* at pci? dev ? function ?

DESCRIPTION

The xge device driver supports the Neterion Xframe-I LR Ethernet adapter, which uses a single mode fiber (1310nm) interface.

The Xframe supports IPv4/TCP/UDP checksumming in hardware, as well as TCP Segmentation Offloading (TSO) and hardware VLAN handling. The driver currently does not support the hardware VLAN feature. See ifconfig(8) for information on how to enable TSO and hardware checksum calculation.

DIAGNOSTICS

xge%s: failed configuring endian, %llx != %llx!
The Xframe could not be turned into the correct endian operation. This is most likely a hardware error.

xge%d: failed allocating txmem.
xge%d: failed allocating rxmem.
The computer has run out of kernel memory.

xge%d: adapter not quiescent, aborting
xge%d: ADAPTER_STATUS missing bits %s
The Xframe could not be turned into a usable state. Most likely an Xframe hardware error.

xge%d: cannot create TX DMA maps
xge%d: cannot create RX DMA maps
This error is either a kernel error or that the kernel has run out of available memory.

xge%d: bad compiler struct alignment, %d != %d
The compiler did not align the structure correctly. This is a compiler problem.

SEE ALSO

arp(4), ifmedia(4), netintro(4), pci(4), ifconfig(8)

HISTORY

The xge driver first appeared in NetBSD 3.0.

AUTHORS

The xge driver was written by Anders Magnusson <ragge@ludd.luth.se>.

BUGS

There should be an XGMII framework for the driver to use.
September 9, 2005 NetBSD 6.1