NAME

css — DEC IMP-11A LH/DH IMP network interface

SYNOPSIS

pseudo-device imp device css0 at uba0 csr 167600 flags 10 vector cssrint cssxint

DESCRIPTION

NOTE: At the moment, NetBSD does not support IMP, so this manual page is not relevant.

The css device provides a Local Host/Distant Host interface to an IMP. It is normally used when participating in the DARPA Internet. The controller itself is not accessible to users, but instead provides the hardware support to the IMP interface described in imp(4). The configuration entry for the imp(4) must also include the pseudo-device as shown above.

DIAGNOSTICS

css%d: not alive.

The initialization routine was entered even though the device did not autoconfigure. This is indicates a system problem.

css%d: can't initialize.

Insufficient UNIBUS resources existed to initialize the device. This is likely to occur when the device is run on a buffered data path on an 11/750 and other network interfaces are also configured to use buffered data paths, or when it is configured to use buffered data paths on an 11/730 (which has none).

css%d: imp doesn't respond, icsr=%b.

The driver attempted to initialize the device, but the IMP failed to respond after 500 tries. Check the cabling.

css%d: stray output interrupt csr=%b.

An interrupt occurred when no output had previously been started.

css%d: output error, ocsr=%b icsr=%b.

The device indicated a problem sending data on output.

css%d: recv error, csr=%b.

The device indicated a problem receiving data on input.

css%d: bad length=%d.

An input operation resulted in a data transfer of less than 0 or more than 1008 bytes of data into memory (according to the word count register). This should never happen as the maximum size of a host-IMP message is 1008 bytes.

HISTORY

The css interface appeared in 4.2BSD.