IXG(4) Kernel Interfaces Manual IXG(4)

NAME

ixgIntel(R) 10Gb Ethernet driver

SYNOPSIS

ixg* at pci? dev ? function ?

DESCRIPTION

The ixg driver provides support for PCI 10Gb Ethernet adapters based on the Intel(R) 82598EB and 82599 10 GbE Controllers. The driver supports Jumbo Frames, TCP Segmentation Offload (TSO).

For questions related to hardware requirements, refer to the documentation supplied with your Intel 10GbE adapter. All hardware requirements listed apply to use with NetBSD.

Support for Jumbo Frames is provided via the interface MTU setting. Selecting an MTU larger than 1500 bytes with the ifconfig(8) utility configures the adapter to receive and transmit Jumbo Frames. On NetBSD, the maximum MTU size for Jumbo Frames is 9000 bytes.

This driver version supports VLANs. For information on enabling VLANs, see ifconfig(8).

HARDWARE

The ixg driver supports the following cards:

DIAGNOSTICS

ixg%d: Unable to allocate bus resource: memory
A fatal initialization error has occurred.
ixg%d: Unable to allocate bus resource: interrupt
A fatal initialization error has occurred.
ixg%d: watchdog timeout -- resetting
The device has stopped responding to the network, or there is a problem with the network connection (cable).

SUPPORT

For general information and support, go to the Intel support website at: http://support.intel.com.

SEE ALSO

arp(4), netintro(4), vlan(4), ifconfig(8)

HISTORY

The ixg device driver comes from FreeBSD, where it is called ixgbe(4). It first appeared in NetBSD 6.0.

AUTHORS

The ixg driver was written by Intel Corporation <freebsdnic@mailbox.intel.com>. It was imported from FreeBSD into NetBSD by David Young <dyoung@NetBSD.org>.

BUGS

The hardware supports a maximum MTU of 16114 bytes, but the NetBSD port of the driver supports only 9000 bytes.

The hardware supports Message-Signalled Interrupts (MSI and MSI-X) and Receive-Side Scaling (RSS), however, these features are not enabled in the NetBSD driver at this time.

July 25, 2011 NetBSD 6.1