IDEIOREAD (Read) IDE Adapter Device Driver ioctl Operation

Purpose

Issues a single block Integrated Device Electronics (IDE) read command to a selected IDE ATA device.

Description

The IDEIOREAD operation allows the caller to issue an IDE device read command to a selected device. System management routines use this command for configuring IDE devices.

The arg parameter of the IDEIOREAD operation is the address of an ide_readblk structure. This structure is defined in the /usr/include/sys/ide.h header file.

This command results in the IDE adapter device driver issuing an ATA READ SECTOR read command. The command is set up to read only a single block. The caller supplies:

Target device IDE device ID
Logical block number or cylinder-head-sector block number to be read
Length (in bytes) of the block on the device
Time-out value (in seconds) for the command
Pointer to the application buffer where the returned data is to be placed
Flags parameter

The maximum block length for this command is 512 bytes. The command will be rejected if the length is found to be larger than this value.

Note: The IDE adapter device driver performs normal error-recovery procedures during execution of this command.

Return Values

When completed successfully, this operation returns a value of 0. Otherwise, a value of -1 is returned and the errno global variable is set to 1 of the following values:

Value	Description
EFAULT	Indicates that a bad copy between kernel and user space occurred.
EINVAL	Indicates that an IDEIOSTART command was not issued prior to this command. If the IDEIOSTART command was issued, then this indicates the block length field value is too large.
EIO	Indicates that an I/O error has occurred. If an EIO value is returned, the caller should retry the IDEIOREAD operation since the first command may have cleared an error condition with the device. In the case of an adapter error, the system error log records the adapter error status information.
ENOCONNECT	Indicates that a bus fault has occurred. Generally, the IDE adapter device driver cannot determine which device caused the bus fault, so this error is not logged.
ENODEV	Indicates that no IDE device responded to the requested IDE device ID. This return value implies that no device exists at the specified IDE device ID. This condition is not necessarily an error and is not logged.
ENOMEM	Indicates insufficient memory is available to complete the command.
ETIMEDOUT	Indicates the device did not respond with status before the internal time-out value expired. The caller should retry this command at least once, since the first command may have cleared an error condition with the device. The system error log records this error.

Files

Item	Description
/dev/ide0, /dev/ide1,..., /dev/iden	Provide an interface to allow IDE device drivers to access IDE devices or adapters.