CIO_QUERY ddioctl Communications PDH Operation

Purpose

Returns device statistics.

Syntax

#include <sys/device.h>
#include <sys/comio.h>

int ddioctl (devno, op, parmptr, devflag, chan, ext) dev_t devno; int op; struct query_parms * parmptr; ulong devflag; int chan, ext;

Parameters

Item	Description
devno	Specifies major and minor device numbers.
op	Indicates the entry point of the CIO_QUERY operation.
parmptr	Points to a query_parms structure. This structure is defined in the /usr/include/sys/comio.h file.
devflag	Specifies the DKERNEL flag. This flag is set by calling kernel-mode processes and cleared by calling user-mode processes.
chan	Specifies channel number assigned by the device handler's ddmpx entry point.
ext	Indicates device-dependent.

Description

The CIO_QUERY operation returns various statistics from the device. Counters are zeroed by the physical device handler when the device is configured. The data returned consists of two contiguous portions. The first portion contains counters to be collected and maintained by all device handlers in the communication I/O subsystem. The second portion consists of device-dependent counters and parameters.

query_parms Parameter Block

For the CIO_QUERY operation, the paramptr parameter points to a query_parms structure. This structure is located in the /usr/include/sys/comio.h file and contains the following fields:

Field	Description
`status`	Contains additional information about the completion of the status block. Besides the status codes listed here, the following device-dependent codes can be returned: CIO_OK Indicates the operation was successful. CIO_INV_CMD Indicates a command was issued that is not valid.
`bufptr`	Points to the buffer where the statistic counters are to be copied.
`buflen`	Indicates the length of the buffer pointed to by the `bufptr` field.
`clearall`	When set to CIO_QUERY_CLEAR, the statistics counters are set to 0 upon return.

Execution Environment

A CIO_QUERY operation can be called from the process environment only.

Return Values

In general, communication device handlers use the common return codes defined for an entry point. However, device handlers for specific communication devices may return device-specific codes. The common return codes for the CIO_QUERY operation are the following:

Return Code	Description
ENXIO	Indicates an attempt to use unconfigured device.
EFAULT	Indicates an address was specified that is not valid.
EINVAL	Indicates a parameter is not valid.
EIO	Indicates an error has occurred.
ENOMEM	Indicates the operation was unable to allocate the required memory.
EBUSY	Indicates the maximum number of opens was exceeded.
ENODEV	Indicates the device does not exist.