lsiscsi Command

Purpose

Displays information for iSCSI target data.

Syntax

lsiscsi [-l AdapterName] [-g group] [-p] [-F Format]

Description

The lsiscsi command displays iSCSI target data from ODM. There are two categories of data stored in ODM. The first is for statically configured iSCSI targets, which require that all the relevant iSCSI target information (such as target name, IP address, and port number) are specified in order for AIX® to discover them. The second category of iSCSI target data is for iSCSI target devices that can be configured automatically, but require authentication from the host (such as passwords). These two categories of iSCSI target data are associated with the static and auto groups, respectively, specified by the -g flag.

Flags

Item	Description
-F Format	Displays the output in a user-specified format, where the Format parameter is a quoted list of column names, separated and possibly ended by nonalphanumeric characters or white space. If white space is used as the separator, the lsiscsi command displays the output in aligned columns.
-g group	Specifies which group this iSCSI target is associated with. There two valid groups are static and auto. The static group is for iSCSI targets that cannot be automatically discovered from this host; all relevant iSCSI target information for them (such as target name, IP address, and port number) must be specified. The auto group is for iSCSI targets that are automatically discovered, but require authentication information such as passwords.
-l AdapterName	Specifies the adapter name for the iSCSI TCP/IP Offload Engine (TOE) adapter that is attached to this iSCSI target. It can also specify the iSCSI protocol device for the iSCSI software solution device.
-p	Displays the iSCSI target's password used for iSCSI logins from this adapter.

Exit Status

Item	Description
0	The command completed successfully.
>0	An error occurred.

Security

The lsiscsi command is executable only by root.

Examples

To list all iSCSI target data for the iSCSI TOE adapter ics0, enter:
```
lsiscsi -l ics0 
```
The system displays output similar to the following:
```
  10.1.2.116 3260 iqn.sn9216.iscsi-hw1
  10.1.2.116 3260 iqn.sn2105.iscsi-target
```

To list all iSCSI target data for this host, enter:

lsiscsi

The system displays output similar to the following:

  ics0 1 10.1.2.116 3260 iqn.sn9216.iscsi-hw1
  ics0 10.1.2.116 3260 iqn.sn2105.iscsi-target
  ics1 11.23.45.67 iqn.mds9216.iscsi_hw2.116 3260 iqn.sn2105.iscsi-target

Location

/usr/sbin/lsiscsi

Files

Item	Description
src/bos/usr/sbin/iscsia	Contains the common source files from which the iSCSI commands are built.