At the moment, VAX is running, but extremely slowly, like 30 min. to compile/link/run a 3-line BASIC program. Anyone else?
Update: OpenVMS/VAX, that is.
VAX slow
Moderator: Moderators
5 posts
• Page 1 of 1
Re: VAX slow
by papa » Wed Nov 30, 2016 6:46 am
Additional information.
VAX is (still) running slowly when connecting via DECnet (SET HOST VAX) from ALPHA. While connecting, the following message is printed, but the connection process continues until eventually displaying a command prompt.
Attempts to connect to VAX via telnet or ssh, from Polarhome hosts or outside, are all failing.
VAX is (still) running slowly when connecting via DECnet (SET HOST VAX) from ALPHA. While connecting, the following message is printed, but the connection process continues until eventually displaying a command prompt.
- Code: Select all
Failure on the back translate address request
Attempts to connect to VAX via telnet or ssh, from Polarhome hosts or outside, are all failing.
-
papa - Senior Member
- Posts: 158
- Joined: Mon Apr 14, 2008 8:55 pm
- Location: Japan Takarazuka
Re: VAX slow
by zoli » Mon Dec 05, 2016 1:28 pm
It died.
I'll check later today.
I'll check later today.
Regards,
Z
---
Zoltan Arpadffy
Z
---
Zoltan Arpadffy
- zoli
- Forum Admin
- Posts: 785
- Joined: Mon Sep 30, 2002 1:27 am
- Location: Stockholm, Sweden
Re: VAX slow
by zoli » Fri Dec 09, 2016 1:50 pm
The OpenVMS/VAX is back again.
The accounting filled up the entire system disk.
The accounting filled up the entire system disk.
Regards,
Z
---
Zoltan Arpadffy
Z
---
Zoltan Arpadffy
- zoli
- Forum Admin
- Posts: 785
- Joined: Mon Sep 30, 2002 1:27 am
- Location: Stockholm, Sweden
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 10 guests